Control Panel Menus
Admin Menu
This section includes information about the following Admin menu sub menus:
•Network Setup Menu on page 99
•USB Setup Menu on page 100
•System Setup Menu on page 101
•Maintenance Mode Menu on page 103
•PCL Setup Menu on page 104
•PostScript Setup Menu on page 106
•Control Panel Menu on page 107
You use the Admin menu to access the printer’s configuration settings.
The following table lists the sub menus contained in the Admin Menu.
Network Setup Menu
Use this menu to configure printer settings for jobs sent to the printer via a network port. Notes:
•The settings in the Network Setup menu cannot be selected when you enter this menu during printing.
•You need to restart the printer to activate menu setting changes. After making changes, switch off the printer and then switch it on again.
Item | Description | |
|
| |
Ethernet | Specifies the Ethernet communication speed and modes. | |
| • Auto (default): Automatically changes between 10M Half Duplex, 10M | |
|
| Full Duplex, 100M Half Duplex, and 100M Full Duplex. |
| • | 10Base Half |
| • | 10Base Full |
| • | 100Base Half |
| • | 100Base Full |
|
| |
TCP/IP | Specifies the settings to use for the TCP/IP protocol: | |
| • IP Mode: IPv4 Mode, IPv6 Mode, or Dual Stack | |
| • IPv4: Get IP Address, IP Address, Network Mask, Gateway Address | |
| • IPsec (IP security protocol; available when enabled) | |
|
|
|
Phaser 6140 Color Laser Printer | 99 |
User Guide |
|