Chapter 8 WAN Screens
Table 37 NETWORK > WAN > Dial Backup > Edit (continued)
LABEL | DESCRIPTION |
Drop DTR When | Select this check box to have the ZyWALL drop the DTR (Data Terminal Ready) |
Hang Up | signal after the "AT Command String: Drop" is sent out. |
|
|
AT Response |
|
Strings |
|
|
|
CLID | Type the keyword that precedes the CLID (Calling Line Identification) in the AT |
| response string. This lets the ZyWALL capture the CLID in the AT response string |
| that comes from the WAN device. CLID is required for CLID authentication. |
|
|
Called ID | Type the keyword preceding the dialed number. |
|
|
Speed | Type the keyword preceding the connection speed. |
|
|
Call Control |
|
|
|
Dial Timeout | Type a number of seconds for the ZyWALL to try to set up an outgoing call before |
(sec) | timing out (stopping). |
|
|
Retry Count | Type a number of times for the ZyWALL to retry a busy or |
| number before blacklisting the number. |
|
|
Retry Interval | Type a number of seconds for the ZyWALL to wait before trying another call after a |
(sec) | call has failed. This applies before a phone number is blacklisted. |
|
|
Drop Timeout | Type the number of seconds for the ZyWALL to wait before dropping the DTR |
(sec) | signal if it does not receive a positive disconnect confirmation. |
|
|
Call Back Delay | Type a number of seconds for the ZyWALL to wait between dropping a callback |
(sec) | request call and dialing the corresponding callback call. |
|
|
Apply | Click Apply to save your changes back to the ZyWALL. |
|
|
Cancel | Click Cancel to exit this screen without saving. |
|
|
170 |
| |
ZyWALL 2 Plus User’s Guide |
| |
|
|
|