ZyXEL Communications 2 Plus 3.4 VPN Wizard Network Setting

Chapter 3 Wizard Setup

Figure 26 VPN Wizard: Gateway Setting

The following table describes the labels in this screen.

Table 15 VPN Wizard: Gateway Setting

LABEL	DESCRIPTION
Gateway Policy
Property

Name	Type up to 32 characters to identify this VPN gateway policy. You may use any
	character, including spaces, but the ZyWALL drops trailing spaces.

Gateway Policy
Setting

My ZyWALL	When the ZyWALL is in router mode, enter the WAN IP address or the domain name
	of your ZyWALL or leave the field set to 0.0.0.0.
	The ZyWALL uses its current WAN IP address (static or dynamic) in setting up the
	VPN tunnel if you leave this field as 0.0.0.0. If the WAN connection goes down, the
	ZyWALL uses the dial backup IP address for the VPN tunnel when using dial backup
	or the LAN IP address when using traffic redirect.
	The VPN tunnel has to be rebuilt if this IP address changes.
	When the ZyWALL is in bridge mode, this field is read-only and displays the
	ZyWALL’s IP address.

Remote	Enter the WAN IP address or domain name of the remote IPSec router (secure
Gateway	gateway) in the field below to identify the remote IPSec router by its IP address or a
Address	domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
	IP address.

Back	Click Back to return to the previous screen.

Next	Click Next to continue.

Use this screen to name the VPN network policy (IPSec SA) and identify the devices behind the IPSec routers at either end of a VPN tunnel.