Chapter 41 Firmware and Configuration File Maintenance
Figure 410 Example Xmodem Upload
After the firmware upload process has completed, the ZyWALL will automatically restart.
41.5.10Uploading Configuration File Via Console Port1Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.2 - System Maintenance - Upload System Configuration File. Follow the instructions as shown in the next screen.
Figure 411 Menu 24.7.2 As Seen Using the Console Port
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1.Enter "y" at the prompt below to go into debug mode.
2.Enter "atlc" after "Enter Debug Mode" message.
3.Wait for "Starting XMODEM upload" message before activating Xmodem upload on your terminal.
4.After successful firmware upload, enter "atgo" to restart the system.
Warning:
1.Proceeding with the upload will erase the current configuration file.
2.The system's console port speed (Menu 24.2.2) may change when it is restarted; please adjust your terminal's speed accordingly. The password may change (menu 23), also.
3.When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to "1234".
Do You Wish To Proceed:(Y/N)
2After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your computer. Follow the procedure as shown previously for the HyperTerminal program. The procedure for other serial communications programs should be similar.
3Enter “atgo” to restart the ZyWALL.
584 |
| |
ZyWALL 2 Plus User’s Guide |
| |
|
|
|