Chapter 29 WAN and Dial Backup Setup
Table 180 Advanced WAN Port Setup: Call Control Parameters
FIELD | DESCRIPTION |
Call Control |
|
|
|
Dial Timeout (sec) | Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing |
| call before timing out (stopping). The ZyWALL times out and stops if it cannot set |
| up an outgoing call within the timeout value. |
|
|
Retry Count | Enter a number of times for the ZyWALL to retry a busy or |
| number before blacklisting the number. |
|
|
Retry Interval (sec) | Enter a number of seconds for the ZyWALL to wait before trying another call after |
| a call has failed. This applies before a phone number is blacklisted. |
|
|
Drop Timeout (sec) | Enter a number of seconds for the ZyWALL to wait before dropping the DTR |
| signal if it does not receive a positive disconnect confirmation. |
|
|
Call Back Delay | Enter a number of seconds for the ZyWALL to wait between dropping a callback |
(sec) | request call and dialing the |
|
|
29.6 Remote Node Profile (Backup ISP)
On the ZyWALL, enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup port connection.
Figure 311 Menu 11.2: Remote Node Profile (Backup ISP)
Menu 11.2 - Remote Node Profile (Backup ISP) | ||
Rem Node Name= Dial |
| |
Active= No | Edit IP= No | |
Outgoing: | ||
Edit Script Options= No | ||
My Login= ChangeMe | Telco Option: | |
My Password= ******** | ||
Retype to Confirm= ******** | Allocated Budget(min)= 0 | |
Authen= CHAP/PAP | Period(hr)= 0 | |
Pri Phone #= 0 | Schedules= | |
Sec Phone #= | Always On= No | |
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
Press ENTER to Confirm or ESC to Cancel:
| 485 |
ZyWALL 2 Plus User’s Guide | |
|
|