ZyXEL Communications 2 Plus 34.6 Traffic Redirect

Chapter 34 Remote Node Setup

Figure 337 Menu 11.1.4: Remote Node Filter (PPPoE or PPTP Encapsulation)

Menu 11.1.4 - Remote Node Filter

Input Filter Sets: protocol filters= device filters= Output Filter Sets: protocol filters= device filters=

Call Filter Sets: protocol filters=

device filters=

Enter here to CONFIRM or ESC to CANCEL:

Configure parameters that determine when the ZyWALL will forward WAN traffic to the backup gateway using Menu 11.1.5 - Traffic Redirect Setup.

Figure 338 Menu 11.1.5: Traffic Redirect Setup

Menu 11.1.5 - Traffic Redirect Setup

Active= Yes

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 14

Check WAN IP Address= 0.0.0.0

Fail Tolerance= 10

Period(sec)= 300

Timeout(sec)= 8

Press ENTER to Confirm or ESC to Cancel:

The following table describes the fields in this menu.

Table 194 Menu 11.1.5: Traffic Redirect Setup

FIELD	DESCRIPTION
Active	Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
	redirect setup. The default is No.

Configuration

Backup Gateway IP	Enter the IP address of your backup gateway in dotted decimal notation.
Address	The ZyWALL automatically forwards traffic to this IP address if the ZyWALL's
	Internet connection terminates.

Metric	This field sets this route's priority among the routes the ZyWALL uses.
	Enter a number from 1 to 15 to set this route's priority among the ZyWALL's
	routes (see Section 8.2 on page 151) The smaller the number, the higher
	priority the route has.