ZyXEL Communications 2 Plus 26.9 Configuring Device Mode (Bridge)

Chapter 26 Maintenance

Figure 285 MAINTENANCE > Device Mode (Router Mode)

The following table describes the labels in this screen.

Table 164 MAINTENANCE > Device Mode (Router Mode)

LABEL	DESCRIPTION
Current Device
Mode

Device Mode	This displays whether the ZyWALL is functioning as a router or a bridge.

Device Mode Setup

Router	When the ZyWALL is in router mode, there is no need to select or clear this radio
	button.

IP Address	Click LAN, WAN, DMZ or WLAN to go to the LAN, WAN, DMZ or WLAN screen
	where you can view and/or change the corresponding settings.

Bridge	Select this radio button and configure the following fields, then click Apply to set
	the ZyWALL to bridge mode.

IP Address	Enter the IP address of your ZyWALL in dotted decimal notation. Use an IP
	address in the same subnet as the network to which you connect the ZyWALL.
	Make sure the IP address does not conflict with any other device on the
	network.

IP Subnet Mask	Enter the IP subnet mask of the ZyWALL.

Gateway IP	Enter the gateway IP address.
Address

Apply	Click Apply to save your changes back to the ZyWALL. After you click Apply,
	please wait for one minute and use the IP address you configured in the IP
	Address field to access the ZyWALL again.
Reset	Click Reset to begin configuring this screen afresh.

Click MAINTENANCE > Device Mode to open the following screen. Use this screen to configure your ZyWALL as a router or a bridge.