ZyXEL Communications 2 Plus manual 439

	Chapter 25 Logs Screens
Table 153 IKE Logs (continued)
LOG MESSAGE	DESCRIPTION
Remote IP <Remote IP> /	The security gateway is set to “0.0.0.0” and the router used
<Remote IP> conflicts	the peer’s “Local Address” as the router’s “Remote Address”.
	This information conflicted with static rule #d; thus the
	connection is not allowed.
Phase 1 ID type mismatch	This router’s "Peer ID Type" is different from the peer IPSec
	router's "Local ID Type".
Phase 1 ID content mismatch	This router’s "Peer ID Content" is different from the peer
	IPSec router's "Local ID Content".
No known phase 1 ID type	The router could not find a known phase 1 ID in the
found	connection attempt.
ID type mismatch. Local /	The phase 1 ID types do not match.
Peer: <Local ID type/Peer ID
type>
ID content mismatch	The phase 1 ID contents do not match.
Configured Peer ID Content:	The phase 1 ID contents do not match and the configured
<Configured Peer ID Content>	"Peer ID Content" is displayed.
Incoming ID Content:	The phase 1 ID contents do not match and the incoming
<Incoming Peer ID Content>	packet's ID content is displayed.
Unsupported local ID Type:	The phase 1 ID type is not supported by the router.
<%d>
Build Phase 1 ID	The router has started to build the phase 1 ID.
Adjust TCP MSS to %d	The router automatically changed the TCP Maximum
	Segment Size value after establishing a tunnel.
Rule <%d> input idle time	The tunnel for the listed rule was dropped because there was
out, disconnect	no inbound traffic within the idle timeout period.
XAUTH succeed! Username:	The router used extended authentication to authenticate the
<Username>	listed username.
XAUTH fail! Username:	The router was not able to use extended authentication to
<Username>	authenticate the listed username.
Rule[%d] Phase 1 negotiation	The listed rule’s IKE phase 1 negotiation mode did not match
mode mismatch	between the router and the peer.
Rule [%d] Phase 1 encryption	The listed rule’s IKE phase 1 encryption algorithm did not
algorithm mismatch	match between the router and the peer.
Rule [%d] Phase 1	The listed rule’s IKE phase 1 authentication algorithm did not
authentication algorithm	match between the router and the peer.
mismatch
Rule [%d] Phase 1	The listed rule’s IKE phase 1 authentication method did not
authentication method	match between the router and the peer.
mismatch
Rule [%d] Phase 1 key group	The listed rule’s IKE phase 1 key group did not match
mismatch	between the router and the peer.
Rule [%d] Phase 2 protocol	The listed rule’s IKE phase 2 protocol did not match between
mismatch	the router and the peer.
Rule [%d] Phase 2 encryption	The listed rule’s IKE phase 2 encryption algorithm did not
algorithm mismatch	match between the router and the peer.

	439
ZyWALL 2 Plus User’s Guide