Chapter 29 WAN and Dial Backup Setup
To edit the advanced setup for the Dial Backup port, move the cursor to the Edit Advanced Setup field in Menu 2 - WAN Setup, press the [SPACE BAR] to select Yes and then press [ENTER].
Figure 310 Menu 2.1: Advanced WAN Setup
Menu 2.1 - Advanced WAN Setup
AT Command Strings: | Call Control: | |
Dial= atdt |
| Dial Timeout(sec)= 60 |
Drop= ~~+++~~ath | Retry Count= 0 | |
Answer= ata |
| Retry Interval(sec)= N/A |
Drop DTR When | Hang Up= Yes | Drop Timeout(sec)= 20 |
Call Back Delay(sec)= 15 | ||
AT Response | Strings: |
|
CLID= NMBR = |
| |
Called Id= |
|
|
Speed= CONNECT |
| |
Press | ENTER to Confirm or ESC to Cancel: | |
The following table describes fields in this menu.
Table 179 Advanced WAN Port Setup: AT Commands Fields
FIELD | DESCRIPTION |
AT Command |
|
Strings: |
|
|
|
Dial | Enter the AT Command string to make a call. |
|
|
Drop | Enter the AT Command string to drop a call. “~” represents a one second wait, |
| e.g., “~~~+++~~ath” can be used if your modem has a slow response time. |
|
|
Answer | Enter the AT Command string to answer a call. |
|
|
Drop DTR When | Press the [SPACE BAR] to choose either Yes or No. When Yes is selected (the |
Hang Up | default), the DTR (Data Terminal Ready) signal is dropped after the “AT |
| Command String: Drop” is sent out. |
|
|
AT Response |
|
Strings: |
|
|
|
CLID (Calling Line | Enter the keyword that precedes the CLID (Calling Line Identification) in the AT |
Identification) | response string. This lets the ZyWALL capture the CLID in the AT response |
| string that comes from the WAN device. CLID is required for CLID |
| authentication. |
|
|
Called Id | Enter the keyword preceding the dialed number. |
|
|
Speed | Enter the keyword preceding the connection speed. |
|
|
484 |
| |
ZyWALL 2 Plus User’s Guide |
| |
|
|
|