ZyXEL Communications 2 Plus 26.10 F/W Upload Screen

	Chapter 26 Maintenance
Table 165 MAINTENANCE > Device Mode (Bridge Mode) (continued)
LABEL	DESCRIPTION
DHCP	DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
	individual clients (computers) to obtain TCP/IP configuration at startup from a
	server. Unless you are instructed by your ISP, leave the DHCP check box
	selected. Clear it to stop the ZyWALL from acting as a DHCP server. When
	configured as a server, the ZyWALL provides TCP/IP configuration for the
	clients. If not, DHCP service is disabled and you must have another DHCP
	server on your LAN, or else the computers must be manually configured. When
	set as a server, fill in the rest of the DHCP setup fields.
IP Pool Starting	This field specifies the first of the contiguous addresses in the IP address pool.
Address
Pool Size	This field specifies the size, or count of the IP address pool.
Bridge	When the ZyWALL is in bridge mode, there is no need to select or clear this
	radio button.
IP Address	Click Bridge to go to the Bridge screen where you can view and/or change the
	bridge settings.
Apply	Click Apply to save your changes back to the ZyWALL. After you click Apply,
	please wait for one minute and use the IP address you configured in the LAN
	Interface IP Address field to access the ZyWALL again.
Reset	Click Reset to begin configuring this screen afresh.

26.10 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a

.bin extension, for example, "zywall.bin". The upload process uses HTTP (Hypertext Transfer Protocol) and may take up to two minutes. After a successful upload, the system will reboot. See Section 41.5 on page 579 for upgrading firmware using FTP/TFTP commands.

Click MAINTENANCE > F/W UPLOAD. Follow the instructions in this screen to upload firmware to your ZyWALL.

Only upload firmware for your specific model!

Figure 287 MAINTENANCE > Firmware Upload

	457
ZyWALL 2 Plus User’s Guide