Chapter 31 Internet Access
31.3Configuring the PPTP Client
"The ZyWALL supports only one PPTP server connection at any given time.
To configure a PPTP client, you must configure the My Login and Password fields for a PPP connection and the PPTP parameters for a PPTP connection.
After configuring My Login and Password for PPP connection, press [SPACE BAR] and then [ENTER] in the Encapsulation field in Menu 4
PPTP as your encapsulation option. This brings up the following screen.
Figure 321 Internet Access Setup (PPTP)
Menu 4 - Internet Access Setup
ISP's Name= ChangeMe
Encapsulation= PPTP
Service Type= N/A
My Login=
My Password= ********
Retype to Confirm= ********
Idle Timeout= 100
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address= N/A
Network Address Translation= SUA Only
Press ENTER to Confirm or ESC to Cancel:
The following table contains instructions about the new fields when you choose PPTP in the Encapsulation field in menu 4.
Table 188 New Fields in Menu 4 (PPTP) Screen
FIELD | DESCRIPTION |
Encapsulation | Press [SPACE BAR] and then press [ENTER] to choose PPTP. The encapsulation |
| method influences your choices for the IP Address field. |
|
|
Idle Timeout | This value specifies the time, in seconds, that elapses before the ZyWALL |
| automatically disconnects from the PPTP server. |
|
|
31.4 Configuring the PPPoE Client
If you enable PPPoE in menu 4, you will see the next screen.
| 499 |
ZyWALL 2 Plus User’s Guide | |
|
|