ZyXEL Communications 2 Plus 18.2 IP Static Route

Chapter 18 Static Route

Click ADVANCED > STATIC ROUTE to open the IP Static Route screen (some of the screen’s blank rows are not shown).

The first static route entry is for the default WAN route. You cannot modify or delete a static default route.

The default route is disabled after you change the static WAN IP address to a dynamic WAN IP address.

Figure 227 ADVANCED > STATIC ROUTE > IP Static Route

The following table describes the labels in this screen.

Table 100 ADVANCED > STATIC ROUTE > IP Static Route

LABEL	DESCRIPTION
#	This is the number of an individual static route.

Name	This is the name that describes or identifies this route.

Active	This field shows whether this static route is active (Yes) or not (No).

Destination	This parameter specifies the IP network address of the final destination. Routing is
	always based on network number.

Gateway	This is the IP address of the gateway. The gateway is a router or switch on the same
	network segment as the ZyWALL’s interface. The gateway helps forward packets to
	their destinations.

Modify	Click the edit icon to go to the screen where you can set up a static route on the
	ZyWALL.
	Click the delete icon to remove a static route from the ZyWALL. A window displays
	asking you to confirm that you want to delete the route.