ZyXEL Communications 2 Plus 3.5 VPN Wizard IKE Tunnel Setting (IKE Phase 1)

Chapter 3 Wizard Setup

Table 16 VPN Wizard: Network Setting

LABEL	DESCRIPTION
Remote	Remote IP addresses must be static and correspond to the remote IPSec router's
Network	configured local IP addresses.
	Select Single for a single IP address. Select Range IP for a specific range of IP
	addresses. Select Subnet to specify IP addresses on a network by their subnet
	mask.

Starting IP	When the Remote Network field is configured to Single, enter a (static) IP address
Address	on the network behind the remote IPSec router. When the Remote Network field is
	configured to Range IP, enter the beginning (static) IP address, in a range of
	computers on the network behind the remote IPSec router. When the Remote
	Network field is configured to Subnet, enter a (static) IP address on the network
	behind the remote IPSec router

Ending IP	When the Remote Network field is configured to Single, this field is N/A. When the
Address/	Remote Network field is configured to Range IP, enter the end (static) IP address, in
Subnet Mask	a range of computers on the network behind the remote IPSec router. When the
	Remote Network field is configured to Subnet, enter a subnet mask on the network
	behind the remote IPSec router.

Back	Click Back to return to the previous screen.

Next	Click Next to continue.

Use this screen to specify the authentication, encryption and other settings needed to negotiate a phase 1 IKE SA.

Figure 28 VPN Wizard: IKE Tunnel Setting