34
Remote Node Setup
This chapter shows you how to configure a remote node.
34.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up Internet access, you are actually configuring a remote node. The following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 - Remote Node Network Layer Options and Menu 11.1.4 - Remote Node Filter.
34.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown below).
Enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your WAN port. Enter 2 to open Menu 11.2 Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup port connection (see Chapter 29 on page 481).
Figure 331 Menu 11: Remote Node Setup
Menu 11 - Remote Node Setup
1.ChangeMe (ISP, SUA)
2.
Enter Node # to Edit:
34.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu.
| 509 |
ZyWALL 2 Plus User’s Guide | |
|
|