Chapter 36 Network Address Translation (NAT)
"You must press [ENTER] at the bottom of the screen to save the whole set. You must do this again if you make any changes to the set – including deleting a rule. No changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 - Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global Start/End IPs.
"An IP End address must be numerically greater than its corresponding IP Start address.
Figure 347 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set
Menu 15.1.1.1 Address Mapping Rule
Type= Server
Local IP:
Start= N/A
End = N/A
Global IP:
Start= 10.10.1.1
End = N/A
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 199 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set
FIELD | DESCRIPTION |
Type | Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are the |
| mapping types discussed in Chapter 17 on page 331. Server allows you to specify multiple |
| servers of different types behind NAT to this computer. See Section 36.4.3 on page 532 for |
| an example. |
|
|
Local IP | Only local IP fields are N/A for server; Global IP fields MUST be set for Server. |
|
|
Start | Enter the starting local IP address (ILA). |
|
|
End | Enter the ending local IP address (ILA). If the rule is for all local IPs, then put the Start IP |
| as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for |
| types. |
|
|
Global IP |
|
|
|
| 527 |
ZyWALL 2 Plus User’s Guide | |
|
|