ZyXEL Communications NBG-417N manual 110

Chapter 8 WAN

The following table describes the labels in this screen.

Table 41 Network > WAN > Advanced

LABEL	DESCRIPTION
Multicast Setup
Multicast	Check this to enable multicasting. This applies to traffic routed from
	the WAN to the LAN.
	Leaving this blank may cause incoming traffic to be dropped or sent
	to all connected network devices.
Windows Networking (NetBIOS over TCP/IP)
Allow between LAN	Select this check box to forward NetBIOS packets from the LAN to
and WAN	the WAN and from the WAN to the LAN. If your firewall is enabled
	with the default policy set to block WAN to LAN traffic, you also
	need to enable the default WAN to LAN firewall rule that forwards
	NetBIOS traffic.
	Clear this check box to block all NetBIOS packets going from the
	LAN to the WAN and from the WAN to the LAN.
Allow Trigger Dial	Select this option to allow NetBIOS packets to initiate calls.
Auto-bridge
Enable Auto-bridge	Select this option to have the NBG-417N switch to bridge mode
mode	automatically when the NBG-417N gets a WAN IP address in the
	range of 192.168.x.y (where x and y are from zero to nine) no
	matter what the LAN IP address is.
Apply	Click Apply to save your changes back to the NBG-417N.
Reset	Click Reset to begin configuring this screen afresh.

110

NBG-417N User’s Guide