ZyXEL Communications P-2602 manual Configuring Port Forwarding

P-2602H(W)(L)-DxA Series User’s Guide

10.5 Configuring Port Forwarding

Note: If you do not assign a Default Server IP address, the ZyXEL Device discards all packets received for ports that are not specified here or in the remote management setup.

Click Network > NAT > Port Forwarding to open the following screen.

See Appendix F on page 371 for port numbers commonly used for particular services.

Figure 81 Port Forwarding

The following table describes the fields in this screen.

Table 49 Port Forwarding

LABEL	DESCRIPTION
Default Server
Setup
Default Server	In addition to the servers for specified services, NAT supports a default server. A
	default server receives packets from ports that are not specified in this screen. If
	you do not assign a Default Server IP address, the ZyXEL Device discards all
	packets received for ports that are not specified here or in the remote management
	setup.
Port Forwarding
Service Name	Select a service from the drop-down list box.
Server IP Address	Enter the IP address of the server for the specified service.
Add	Click this button to add a rule to the table below.
#	This is the rule index number (read-only).
Active	Click this check box to enable the rule.
Service Name	This is a service’s name.
Start Port	This is the first port number that identifies a service.
End Port	This is the last port number that identifies a service.
Server IP Address	This is the server’s IP address.

Chapter 10 Network Address Translation (NAT) Screens 147