
P-2602H(W)(L)-DxA Series User’s Guide
Figure 104 Firewall Rules
The following table describes the labels in this screen.
Table 71 Firewall Rules
LABEL | DESCRIPTION |
|
|
Firewall Rules | This |
Storage Space | firewall rules it is currently using. When you are using 80% or less of the storage |
in Use | space, the bar is green. When the amount of space used is over 80%, the bar is red. |
Packet Direction | Use the |
| want to configure firewall rules. |
Create a new | Select an index number and click Add to add a new firewall rule after the selected |
rule after rule | index number. For example, if you select “6”, your new rule becomes number 7 and |
number | the previous rule 7 (if there is one) becomes rule 8. |
| The following |
| traffic traveling in the selected packet direction. The firewall rules that you configure |
| (summarized below) take priority over the general firewall action settings in the |
| General screen. |
# | This is your firewall rule number. The ordering of your rules is important as rules are |
| applied in turn. |
Active | This field displays whether a firewall is turned on or not. Select the check box to |
| enable the rule. Clear the check box to disable the rule. |
Source IP | This |
| which this firewall rule applies. Please note that a blank source or destination |
| address is equivalent to Any. |
Destination IP | This |
| which this firewall rule applies. Please note that a blank source or destination |
| address is equivalent to Any. |
Service | This |
| Appendix 31 on page 371 for more information. |
Action | This field displays whether the firewall silently discards packets (Drop), discards |
| packets and sends a TCP reset packet or an ICMP |
| message to the sender (Reject) or allows the passage of packets (Permit). |
Schedule | This field tells you whether a schedule is specified (Yes) or not (No). |
|
|
198 | Chapter 14 Firewall Configuration |