P-2602H(W)(L)-DxA Series User’s Guide
Figure 48 Internet Access Setup (PPPoE)
The following table describes the labels in this screen.
Table 26 Internet Access Setup
LABEL | DESCRIPTION |
|
|
General |
|
|
|
Mode | Select Routing (default) from the |
| computers to share an Internet account. Otherwise select Bridge. |
Encapsulation | Select the method of encapsulation used by your ISP from the |
| box. Choices vary depending on the mode you select in the Mode field. |
| If you select Bridge in the Mode field, select either PPPoA or RFC 1483. |
| If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET |
| ENCAP or PPPoE. |
User Name | (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your |
| ISP assigned. If assigned a name in the form user@domain where domain |
| identifies a service name, then enter both components exactly as given. |
Password | (PPPoA and PPPoE encapsulation only) Enter the password associated with the |
| user name above. |
Service Name | (PPPoE only) Type the name of your PPPoE service here. |
|
|
Multiplexing | Select the method of multiplexing used by your ISP from the |
| Choices are VC or LLC. |
Virtual Circuit ID | VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual |
| circuit. Refer to the appendix for more information. |
|
|
VPI | The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. |
|
|
Chapter 7 WAN Setup | 99 |