P-2602H(W)(L)-DxA Series User’s Guide
AP P E N D I X G
Firewall Commands
Sys Firewall Commands
The following describes the firewall commands. See the Command Interpreter appendix for information on the command structure. Each of these commands must be preceded by sys firewall when you use them. For example, type sys firewall active yes to turn on the firewall.
Table 151 Sys Firewall Commands
Command |
| Description |
|
|
|
acl |
|
|
| disp | Displays ACLs or a specific ACL set # and rule #. |
active | <yesno> | Active firewall or deactivate firewall |
|
| Enables/disables the firewall. |
cnt |
|
|
| disp | Displays the firewall log type and count. |
| clear | Clears the firewall log count. |
pktdump |
| Dumps the last 64 bytes of packets that the firewall has dropped. |
dynamicrule | display | Displays the firewall’s dynamic rules. |
tcprst |
|
|
| rst | Turns TCP reset sending on/off. |
| rst113 | Turns TCP reset sending for port 113 on/off. |
| display | Displays the TCP reset sending settings. |
icmp |
| This rule is not in use. |
dos |
|
|
| smtp | Enables/disables the SMTP DoS defender. |
| display | Displays the SMTP DoS defender setting. |
| ignore | Sets if the firewall will ignore DoS attacks on the lan/wan. |
ignore |
|
|
| dos | Sets if the firewall will ignore DoS attacks on the lan/wan. |
| triangle | Sets if the firewall will ignore triangle route packets on the lan/wan. |
Appendix G Firewall Commands | 375 |