P-2602H(W)(L)-DxA Series User’s Guide

Note: For security reasons, the ZyXEL Device automatically logs you out if you do not use the web configurator for five minutes. If this happens, log in again.

Figure 9 Wizard or Advanced Screen

2.1.2 The RESET Button

You can use the RESET button at the back of the device to turn the wireless LAN off or on. You can also use it to activate OTIST in order to assign your wireless security settings to wireless clients. If you forget your password or cannot access the web configurator, you will need to use the RESET button to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “1234”. You can also use the

2.1.2.1 Using The Reset Button

1Make sure the POWER LED is on (not blinking).

2Do one of the following.

To turn the wireless LAN off or on, press the RESET button for one second and release it. The WLAN LED should change from on to off or vice versa. (“W” models only)

To activate OTIST in order to assign your wireless security settings to wireless clients, press the RESET button for five seconds and release it. The WLAN LED should flash while the device uses OTIST to send wireless settings to OTIST clients.(“W” models only)

To set the device back to the factory default settings, press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts.

Chapter 2 Introducing the Web Configurator

51

Page 51
Image 51
ZyXEL Communications P-2602 manual Using The Reset Button