|
| Chapter 19 Policy |
| Table 43 Policy (continued) | |
| LABEL | DESCRIPTION |
| Outgoing | Select Send the packet to the mirror port to sent the packet to the mirror port. |
|
| Select Send the packet to the egress port to send the packet to the egress port. |
|
| Select Send the matching frames (broadcast or DLF, multicast, marked for |
|
| dropping or to be sent to the CPU) to the egress port to send the broadcast, |
|
| multicast, DLF, |
|
| Select Set the packet’s VLANID to set the VLAN ID of the packet with the value you |
|
| configure in the VLANID field. |
| Metering | Select Enable to activate bandwidth limitation on the traffic flow(s) then set the |
|
| actions to be taken on |
|
|
|
| Select the action(s) to be performed for | |
| Action | Select Drop the packet to discard the |
|
| Select Change the DSCP Value to replace the DSCP field with the value specified in |
|
| the |
|
| Select Do not drop the matching frame previously marked for dropping to queue |
|
| the frames that are marked to be dropped. |
|
|
|
| Add | Click Add to inset the entry to the summary table below. |
|
|
|
| Cancel | Click Cancel to reset the fields back to your previous configuration. |
|
|
|
| Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
|
| Index | This field displays the policy index number. Click an index number to edit the policy. |
|
|
|
| Active | This field displays Yes when policy is activated and No when is it deactivated. |
|
|
|
| Name | Enter a descriptive name (up to 32 printable ASCII characters) for identification |
|
| purposes. |
|
|
|
| Classifier(s) | This field displays the name(s) of the classifier to which this policy applies. |
|
|
|
| Delete | Click Delete to remove the selected entry from the summary table. |
|
|
|
| Cancel | Click Cancel to clear the Delete check boxes. |
|
|
|
19.3 Policy Example
The figure below shows an example Policy screen where you configure a policy to limit bandwidth and discard
| 137 |
|
|