Chapter 34 IEEE 802.1Q Tagged VLAN Commands
This command sets the switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave All Timer to 11000 milliseconds.
sysname(config)# garp join 300 leave 800 leaveall 11000
34.2.3 GVRP Timer
Syntax:
show vlan1q gvrp
This command shows the switch’s GVRP settings.
An example is shown next.
sysname# show vlan1q gvrp GVRP Support
gvrpEnable = YES GVRP Support
34.2.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
34.2.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
34.3 Port VLAN Commands
You must configure the switch port VLAN settings in
34.3.1 Set Port VID
Syntax:
pvid <VID>
| 261 |
|
|