Chapter 32 Introducing the Commands
Table 82 interface
COMMAND |
| DESCRIPTION | P | |
|
| Disables the protocol based VLAN. | 13 | |
|
|
|
| |
|
|
|
| |
|
|
|
| |
|
| vlan <vid> priority |
|
|
|
|
|
| |
| pvid |
| The default PVID is VLAN 1 for all | 13 |
|
|
| ports. Sets a PVID in the range 1 to |
|
|
|
| 4094 for the specified interface. |
|
|
|
|
|
|
| qos priority | Sets the quality of service priority for | 13 | |
|
|
| an interface. |
|
| Sets the duplex mode (half or | 13 | ||
|
| full) and speed (10, 100 or 1000 |
| |
|
| Mbps) of the connection on the |
| |
|
|
| interface. Selecting auto (auto- |
|
|
|
| negotiation) makes one port able to |
|
|
|
| negotiate with a peer automatically to |
|
|
|
| obtain the connection speed and |
|
|
|
| duplex mode that both ends support. |
|
|
|
|
|
|
| test |
| Performs an interface loopback test. | 13 |
| priority | Sets the priority of the specified port(s) | 13 | |
|
|
| in VLAN stacking. |
|
|
| role <normal | Sets the VLAN stacking port roles of | 13 |
|
| access tunnel> | the specified port(s). |
|
|
| SPVID | Sets the service provider VID of the | 13 |
|
|
| specified port(s). |
|
|
| Enables VLAN Trunking on ports | 13 | |
|
|
| connected to other switches or routers |
|
|
|
| (but not ports directly connected to |
|
|
|
| end users) to allow frames belonging |
|
|
|
| to unknown VLAN groups to pass |
|
|
|
| through the switch. |
|
|
|
|
|
|
| weight <wt1> |
| Sets the queuing weight. | 13 |
| <wt2> ... |
|
|
|
| <wt8> |
|
|
|
The following table lists the mvr commands in configuration mode.
Table 83 mvr Commands
COMMAND |
| DESCRIPTION | P | |
mvr <1- |
|
| Enters the MVR (Multicast VLAN | 13 |
4094> |
|
| Registration) configuration mode. |
|
|
| Select a priority level | 13 | |
|
|
| the switch replaces the priority in |
|
|
|
| outgoing IGMP control packets |
|
|
|
| (belonging to this multicast VLAN). |
|
|
|
|
|
|
| exit |
| Exist from the MVR configuration | 13 |
|
|
| mode. |
|
236 |
| |
| ||
|
|
|