Chapter 32 Introducing the Commands

32.2 Accessing the CLI

You can use a direct console connection or Telnet to access the CLI on the switch.

"The switch automatically logs you out of the management interface after five minutes of inactivity. If this happens to you, simply log back in again.

32.2.1Multiple Login

You can use a direct console connection or Telnet to access the command interpreter on the switch.

"The switch automatically logs you out of the management interface after five minutes of inactivity. If this happens to you, simply log back in again.

By default, the multi-login feature is enabled to allow multiple CLI management sessions.

Use the configure multi-logincommand in the configuration mode to allow multiple concurrent logins. However, no more than five concurrent login sessions are allowed. To disable this feature, use the configure no multi-logincommand.

32.2.2The Console Port

Connect to the switch’s console port using a terminal emulation software configured to the following settings:

VT100 terminal emulation

9600 bps

No parity

8 data bits

1 stop bit

No flow control

210

 

VES-1616F-3x Series User’s Guide