Chapter 14 Link Aggregation
Table 33 Link Aggregation Control Protocol Status (continued)
LABEL | DESCRIPTION |
Poll Interval(s) | The text box displays how often (in seconds) this screen refreshes. You may change |
| the refresh interval by typing a new number in the text box and then clicking Set |
| Interval. |
|
|
Stop | Click Stop to halt statistic polling. |
|
|
14.3 Link Aggregation Setup
Click Configuration in the Link Aggregation Control Protocol Status screen to display the screen shown next.
See Section 14.1 on page 113 for background information.
Figure 43 Link Aggregation Control Protocol > Configuration
The following table describes the labels in this screen.
Table 34 Link Aggregation Control Protocol > Configuration
LABEL | DESCRIPTION |
Link Aggregation Control Protocol | |
|
|
Active | Select this checkbox to enable Link Aggregation Control Protocol (LACP). |
|
|
System | LACP system priority is a number between 1 and 65,355. The switch with the lowest |
Priority | system priority (and lowest port number if system priority is the same) becomes the |
| LACP “server”. The LACP “server” controls the operation of LACP setup. Enter a |
| number to set the priority of an active port using Link Aggregate Control Protocol |
| (LACP). The smaller the number, the higher the priority level. |
|
|
Group ID | The field identifies the link aggregation group, that is, one logical link containing |
| multiple ports |
|
|
Active | Select this option to activate a trunk group. |
|
|
Dynamic | Select this check box to enable LACP for a trunk. |
(LACP) |
|
|
|
Port | This field displays the port number. |
|
|
Group | Select the trunk group to which a port belongs. |
|
|
| 115 |
|
|