|
| Chapter 18 Classifier |
| Table 40 Classifier (continued) | |
| LABEL | DESCRIPTION |
| Ethernet Type | Select an Ethernet type or select Other and enter the Ethernet type number in |
|
| hexadecimal value. Refer to Table 41 on page 130 for information. |
|
| Select All if you don’t know. |
|
|
|
| Source |
|
|
|
|
| MAC | Select Any to apply the rule to all MAC addresses. |
| Address | To specify a source, select MAC and type a MAC address in valid MAC address |
|
| format (six hexadecimal character pairs). |
|
|
|
| Port | Select the port to which the rule should be applied. You may choose one port only or |
|
| all ports (All Ports). |
|
|
|
| Destination |
|
|
|
|
| MAC Address | Select Any to apply the rule to all MAC addresses. |
|
| To specify a destination, select the second choice and type a MAC address in valid |
|
| MAC address format (six hexadecimal character pairs). |
|
|
|
| Layer 3 |
|
| Specify the fields below to configure a layer 3 classifier. | |
|
|
|
| DSCP | Select Any to classify traffic from any DSCP or select the second option and specify a |
|
| DSCP (DiffServ Code Point) number between 0 and 63 in the field provided. |
|
|
|
| IP Protocol | Select an IP protocol type or select Other and enter the protocol number in decimal |
|
| value. Refer to Table 42 on page 130 for more information. |
|
| You may select Establish Only for TCP protocol type. This means that the switch will |
|
| pick out the packets that are sent to establish TCP connections. |
|
|
|
| Source |
|
|
|
|
| IP | Enter a source IP address in dotted decimal notation. |
| Address/ | Specify the address prefix by entering the number of ones in the subnet mask. |
| Address | |
|
| |
| Prefix |
|
|
|
|
| Socket | Note: You must select either UDP or TCP in the IP Protocol field |
| Number | |
| before you configure the socket numbers. | |
|
| |
|
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the |
|
| second option and enter a TCP/UDP protocol port number. |
|
|
|
| Destination |
|
|
|
|
| IP | Enter a destination IP address in dotted decimal notation. |
| Address/ | Specify the address prefix by entering the number of ones in the subnet mask. |
| Address | |
|
| |
| Prefix |
|
|
|
|
| Socket | Note: You must select either UDP or TCP in the IP Protocol field |
| Number | |
| before you configure the socket numbers. | |
|
| |
|
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the |
|
| second option and enter a TCP/UDP protocol port number. |
|
|
|
| Add | Click Add to save the changes. |
|
|
|
| Cancel | Click Cancel to reset the fields back to your previous configuration. |
|
|
|
| Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
|
| Index | This field displays the index number of the rule. Click an index number to edit the rule. |
|
|
|
| Active | This field displays Yes when the rule is activated and No when is it deactivated. |
|
|
|
| 129 |
|
|