Chapter 33 Command Examples

An example is shown next.

Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the switch.

Enable ports one, three, four and five for configuration.

Enable GVRP on the interface.

sysname(config)# vlan1q gvrp sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# gvrp

33.9.7 ingress-check

Syntax:

ingress-check

Enables the device to discard incoming frames for VLANs that are not included in a port member set.

An example is shown next.

Enable ports one, three, four and five for configuration.

Enable ingress checking on the interface.

sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# ingress-check

33.9.8 frame-type

Syntax:

frame-type <alltaggeduntagged>

where

<alltaggedu

Choose to accept both tagged and untagged incoming frames or just

ntagged>

tagged or untagged incoming frames on a port.

An example is shown next.

Enable ports one, three, four and five for configuration.

Enable ingress checking on the ports.

Enable tagged frame-types on the interface.

sysname(config)# interface port-channel 1,3-5 sysname(config-interface)# ingress-check sysname(config-interface)# frame-type tagged

33.9.9 egress set

Syntax:

egress set <port-list>

256

 

VES-1616F-3x Series User’s Guide