Chapter 7 VLAN
7.5.2 Configure a Static VLANTo configure a static VLAN, click Static VLAN in the VLAN Status screen to display the screen as shown next.
Use a static VLAN to decide whether an incoming frame on a port should be
•sent to a VLAN group as normal depends on its VLAN tag.
•sent to a group whether it has a VLAN tag or not.
•blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified VID. Refer to Section 7.1 on page 87 for background information.
Figure 31 VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 19 VLAN > Static VLAN
LABEL | DESCRIPTION |
ACTIVE | Select this check box to activate the VLAN settings. |
|
|
Name | Enter a descriptive name for the VLAN group for identification purposes. |
|
|
VLAN Group ID | Enter the VLAN ID for this static VLAN; the valid range is between 1 and 4094. |
|
|
Port | The port number identifies the port you are configuring. |
|
|
Control | Select Normal for the port to dynamically join this VLAN group using GVRP. This is |
| the default selection. |
| Select Fixed for the port to be a permanent member of this VLAN group. |
| Select Forbidden if you want to prohibit the port from joining this VLAN group. |
|
|
Tagging | Select TX Tagging if you want the port to tag all outgoing frames (that were |
| previously untagged) transmitted with this VLAN Group ID. |
|
|
Add | Click Add to add the settings as a new entry in the summary table below. |
|
|
| 91 |
|
|