Chapter 34 IEEE 802.1Q Tagged VLAN Commands

where

<VID> = Specifies the VLAN number between 1 and 4094

This command sets the default VLAN ID on the port(s).

The following example sets the default VID to 200 on ports 1 to 5.

sysname(config)# interface port-channel 1-5 sysname(config-interface)# pvid 200

34.3.2 Set Acceptable Frame Type

Syntax:

frame-type <alltagged>

where

<alltagged> = Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet frames.

This command sets the specified port to accept all Ethernet frames or only those with an IEEE 802.1Q VLAN tag.

The following example sets ports 1 to 5 to accept only tagged frames.

sysname(config)# interface port-channel 1-5 sysname(config-interface)# frame-type tagged

34.3.3 Enable or Disable Port GVRP

Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable GVRP.

The following example turns off GVRP for ports 1 to 5.

sysname(config)# interface port-channel 1-5 sysname(config-interface)# no gvrp

34.3.4 Modify Static VLAN

Use the following commands in the config-vlanmode to configure the static VLAN table.

262

 

VES-1616F-3x Series User’s Guide