|
| Chapter 7 VLAN |
| Table 20 VLAN > VLAN Port Setting (continued) | |
| label | description |
|
|
|
| GVRP | Select this check box to allow GVRP on this port. |
|
|
|
| Acceptable | Specify the type of frames allowed on a port. Choices are All, Tag Only and |
| Frame Type | Untag Only. |
|
| Select All to accept all untagged or tagged frames on this port. This is the default |
|
| setting. |
|
| Select Tag Only to accept only tagged frames on this port. All untagged frames |
|
| will be dropped. |
|
| Select Untag Only to accept only untagged frames on this port. All tagged frames |
|
| will be dropped. |
|
|
|
| VLAN Trunking | Enable VLAN Trunking on ports connected to other switches or routers (but not |
|
| ports directly connected to end users) to allow frames belonging to unknown VLAN |
|
| groups to pass through the switch. |
|
|
|
| Apply | Click Apply to save the changes |
|
|
|
| Cancel | Click Cancel to start configuring the screen again. |
|
|
|
7.6 Port-based VLAN
"
"
When you activate
In screens (such as IP Setup and Filtering) that require a VID, you must enter 1 as the VID.
The
7.6.1 Configure a Port-based VLAN
Select Port Based as the VLAN Type in the Switch Setup screen (see Figure 29 on page 89) and then click VLAN from the navigation panel to display the next screen.
| 93 |
|
|