Chapter 33 Command Examples
•Remove the remote host with IP address 172.165.1.9 and with an
sysname(config)# no ssh key rsa1 sysname(config)# no ssh
33.9 interface Commands
These are some commonly used commands that belong to the interface group of commands.
33.9.1 interface port-channel
Syntax:
interface
Use this command to enable the specified ports for configuration. Type multiple ports or port ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
The following example shows you how to access the interface command mode to configure ports 1, 3, 4 and 5.
•Enter the configuration mode.
•Enable ports one, three, four and five for configuration.
•Begin configuring for those ports.
sysname# config
sysname(config)# interface
33.9.2 bpdu-control
Syntax:
where
<peertunneldiscardnetwork = | Type peer to process any BPDUs received |
> | on these ports. |
| Type tunnel to forward BPDUs received |
| on these ports. |
| Type discard to drop any BPDUs received |
| on these ports. |
| Type network to process and forward |
| BPDUs with a VLAN tag and to process |
| untagged BPDUs. |
| 253 |
|
|