Chapter 32 Introducing the Commands
sysname> ? | Turn on privileged commands |
enable | |
exit | Exit from the EXEC |
help | Description of the interactive help system |
history | Show a list of previously run commands |
logout | Exit from the EXEC |
ping | Exec ping |
show | Show system information |
ssh | SSH client |
traceroute | Exec traceroute |
sysname> |
|
32.5.2 Detailed Command Information
Enter <command> help to display detailed sub command and parameters.
Enter <command> ? to display detailed help information about the sub commands and parameters.
sysname> ping help Commands available: ping <ip>
<
[
[
>
sysname>
sysname> ping ? | destination | ip address |
help | Description | of ping help |
sysname> |
|
|
32.6 Changing the Password
This command is used to change the password for Enable mode. By default the same password is used to enter the command line interface (CLI) and Enable and Config modes of the CLI.
The password you change with this command is required to enter Enable and Config modes of the CLI.
Syntax:
password <password>
where |
|
<password> | = Specifies the new password (up to 32 alphanumeric |
| characters) users have to type in to enter Enable and Config |
| modes. |
214 |
| |
| ||
|
|
|