34

IEEE 802.1Q Tagged VLAN Commands

This chapter describes the IEEE 802.1Q Tagged VLAN and associated commands.

34.1 Configuring Tagged VLAN

Refer to Chapter 7 on page 87 for background information on VLANs.

The following procedure shows you how to configure tagged VLAN.

1Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.

Use the vlan <vlan-id>command to configure or create a VLAN on the switch. The switch automatically enters the config-vlanmode. Use the inactive command to deactivate the VLAN(s).

Use the interface port-channel <port-list> command to enter the config- interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>command to set the VLAN ID you created for the port-list to that specific port in the PVID table.

Use the exit command when you are finished configuring the VLAN.

Example:

sysname(config)# vlan 2000 sysname(config-vlan)# name up1 sysname(config-vlan)# fixed 10-12 sysname(config-vlan)# no untagged 10-12 sysname(config-vlan)# exit sysname(config)# interface port-channel 10-12 sysname(config-interface)# pvid 2000 sysname(config-interface)# exit

2Configure your management VLAN.

Use the vlan <vlan-id>command to create a VLAN (VID 3 in this example) for managing the switch, and the switch will activate the new management VLAN.

Use the inactive command to disable the new management VLAN.

 

259

VES-1616F-3x Series User’s Guide