ADC MM702G2 Determine What YOU Need, Required Equipment, Equipment Requirement, Ethernet hub

Chapter 1: Installation April 14, 2006

DETERMINE WHAT YOU NEED

In addition to what is shipped with the modem, you need the following hardware and software to complete the installation and configuration.

	Table 1-1. Required Equipment
Equipment:	Requirement:
PC	Hardware:
	Ethernet NIC Card (10 Mbps) installed in each PC and other network equipment that will be
	connected to the LAN. Verify if the NIC in the device which directly connects to the modem
	LAN port is half- or full-duplex. The modem LAN port must be set to the same transmission
	direction(s) as the NIC.
	Optional—serial interface card installed in PC (used for access to the modem console port).
	Software:
	TCP/IP protocol stack installed (see the operating system documentation for information).
	Terminal emulation program (such as HyperTerminal) installed for access to the command
	line interface through the console port (see the operating system documentation for
	information).
	Web browser installed (such as, Internet Explorer® Version 4.0 or higher).
	Operating System CD-ROM (Win98, Win98SE, Win2000, WinME, or WinXP).
Ethernet hub,	Optional—use either a hub, switch, or a router to connect multiple PCs or other LAN
switch, or router	equipment to the modem’s Ethernet 10/100Base-T port (LAN port).

1-2 MM70xG2-UM-03