ADC MM702G2, MM701G2 user manual Configure a NEW WAN Session, WAN Configuration

Chapter 4: Configuring the WAN April 14, 2006

CONFIGURE A NEW WAN SESSION

You can configure up to 32 total PPPoA, PPPoE, 1483-Bridge, and 1483-Router sessions for the modem. See page 25 for the maximum number of sessions per each protocol type that can be set up. A default bridging session is set up. From the WAN configuration page (Figure 4-1), define the parameters for each session.

Step		Action
1	Select WAN on the menu bar to access the WAN Configuration page.
		Figure 4-1. WAN Configuration Page
2	To add a new session, choose one of the following protocols from Select a new session type.
	• RFC 1483 bridged if the modem forwards packets based on MAC addresses. You can enable Span-
		ning Tree when you select Bridge sessions. See “Change Spanning Tree Setting” on page 5-10.
	•	RFC 1483 routed if the modem routes packets based on IP addresses.
	•	PPPoA routed if the modem establishes PPP sessions over ATM with the service provider and routes
		packets based on IP addresses.
	•	PPPoE routed if modem establishes PPP sessions over Ethernet with the service provider and routes
		packets based on IP addresses.
3	Click Configure to access the session page for the protocol type you selected.
4	Go to the appropriate section that follows for the protocol that you selected.

F4 and F5 OAM are enabled on default PVCs (0/35 and 0/100) and on every new PVC that is created.

4-2 MM70xG2-UM-03