
Appendix A: Command Line Interface Access | April 14, 2006 |
Step | Action |
1• Sustain Cell Rate
(cont.) | Enter 6 then type the QoS Sustainable Cell Rate (SCR) value supplied by your service provider. Use |
| |
| for CBR, |
| transferred, measured in cells per second. The SCR must be less than the PCR. The valid range is |
|
•Maximum burst size
Enter 7 then type the QoS Maximum Burst Size (MBS) value supplied by your service provider. Use with
•Encapsulation
Type 8 then select the encapsulation type as indicated by the service provider. The options are:
•WAN DHCP Enable
Type 9 then select 1 to Disable or 2 to Enable DHCP client. Enabling DHCP client provides the capability where this session will automatically received an IP address from the service provider via a DHCP server. If you enable DHCP client, leave the next two fields, WAN IP address and WAN Network Mask, blank. These fields will automatically receive values.
•WAN IP Address
Type 10 then enter the IP address provided by the service provider for this session unless you have enabled WAN DHCP. The default IP address is 0.0.0.0.
•WAN Network Mask
Type 11 then enter the network mask provided by the service provider for this session unless you have enabled WAN DHCP. The default WAN Network Mask is 0.0.0.0.
•RIP Accept Mode
Type 12 then select one of the following:
•RIP Send Mode
Type 13 then select one of the following:
2Enter 14 to Apply the new setting and to add the new RFC1483 routed session to your session list; or you can enter 15 to Delete session.