April 14, 2006 | Chapter 7: Implementing a | |
Configure the Remote LAN | ||
|
|
|
Step |
| Action |
1 | Select LAN on the menu bar, then select LAN Setup under LAN Options to access the LAN | |
| Configuration page (Figure | |
|
| Figure |
|
| |
2 | In the LAN Protocol box, confirm that the protocol is set to Bridged. | |
|
| Note: If the protocol is not set to bridged, it can be changed only through the command line |
|
| interface. |
| See Appendix A: “Command Line Interface Access” on page | |
| change the LAN protocol. | |
| + |
|
|
| Note: Any device (such as a PC) connecting to the modem LAN interface loses its connection |
|
| when the modem LAN IP address is changed. After the IP address is changed, you need to |
|
| specify this new address in the Web browser to reconnect a device. |
|
| |
3 | In the IP Address box, enter an available IP address on your subnet. | |
|
| |
4 | Click Apply. | |
|
|
|
