Agilent Technologies E5810A manual Telnet Commands for the E5810, Appendix B

Using the Telnet Utility

Telnet Commands for the E5810

Telnet Commands for the E5810

This table lists the Telnet commands you can use with the E5810. You should use the Telnet configuration commands only if you are using the Telnet configuration method to configure the E5810.You can see a summary of all Telnet commands online by typing ? at any time within the Telnet utility.

	NOTE
	The Telnet utility is the ONLY way to clear syslog messages. When the
	syslog message queue is full, new messages will not be accepted and
	will not overwrite existing syslog messages. Use the syslog-clear
	command to clear syslog messages.
Command		Description
help		View Help Information
?		View Available Commands
config		View Configured Settings
serial-num		View the Device Serial Number
version		View the Firmware Revision
hardware-addr		View the Ethernet (MAC) Address
dhcp <OFFON>		Turn OFF or ON the use of DHCP
ip <ip address>		View/Set the IP Address
subnet-mask <ip address>		View/Set the Network Subnet Mask
gateway <ip address>		View/Set the Gateway Address
dns-server<ip address>		View/Set the DNS Server Address
hostname <string*35>		View/Set the Internet Hostname
description <string*40>		View/Set Device Description (UPnP Friendly Name)
upnp <OFFON>		Turn OFF or ON the use of UPnP
lan-timeout <seconds>		View/Set the LAN Timeout (Keepalive). 0 is Off.
io-timeout <seconds>		View/Set the Server I/O Timeout. 0 is Off.

144 Appendix B