Agilent Technologies E5810A manual Will be used during startup

Using E5810 Web Access

Viewing and Modifying Configuration

Parameter	Description
[Default]

Dynamic Host	DHCP OFF: If DHCP is OFF or unavailable, during startup the E5810 will
Configuration	use the static IP address that may be input in the Configuring your E5810
Protocol (DHCP)	LAN/GPIB Gateway page. In this case, the values for the IP Address,
[ON]	Subnet Mask, and Default Gateway shown in the Configured Value column
(cont’d)
	of the page will be used during startup.
E5810 Serial	The individual Serial Number assigned at the factory for each E5810. The
Number	Serial Number is printed on a label on the underside of the E5810 and
[Factory-Set]	has the form US12345678.
Ethernet (MAC)	This is the Media Access Control Address, also known as the link-level
Address	address, the Ethernet (station) Address, the LANIC ID and Hardware
[Factory-Set]	Address. This is a unique 48-bit address assigned by the manufacturer
	for each Ethernet device. The address is usually 12 hexadecimal
	characters, with colon or dash separators between every two characters,
	such as “00:30:D3:05:00:23” or “00-30-D3-05-00-23”. The Ethernet
	address is printed on a label on the underside of the E5810.
GPIB Address	This value configures the GPIB bus address of the E5810. This address
[21]	is used when transfers are made on the GPIB bus. A SICL client
	application can change this value by using the SICL function
	IGPIBBUSADDR. The GPIB address value can be any number 0 through
	30.
GPIB Logical Unit	This value is the interface logical unit (LU) number of the GPIB interface
[7]	in the E5810. It may be used in an Agilent SICL client application’s iopen
	statement to uniquely identify the GPIB interface in the E5810. The GPIB
	logical unit value can be any number 1 through 255.
GPIB SICL Interface	This value is the symbolic name of the GPIB interface in the E5810. It is
Name	used in a SICL client application’s iopen operation to symbolically
[gpib0]	reference the GPIB interface in the E5810. The maximum length of the
	GPIB interface name is 15 characters. If VXI-11 (TCP/IP Instrument
	Protocol) is used, the name must be gpib<n>. The names “hpib” or
	“hpib7” may be used to more easily support legacy programs, if only
	SICL/LAN protocols will be used.

90 Chapter 3