Installing the E5810

Installing the E5810 on an Enterprise Network

Installing the E5810 on an Enterprise

Network

This step gives guidelines to install an E5810 on an Enterprise network.

NOTE

If your Enterprise network does not support Dynamic Host Configuration Protocol (DHCP), you must first configure your E5810 on a Local network as shown in “Configuring the E5810 on a Local Network” and then return to this step to install the E5810 on the Enterprise network.

Connecting the E5810 to the Network

This figure shows typical E5810 connections to an Enterprise network. You can connect up to 14 GPIB instruments and one RS-232 instrument to each E5810. Make connections from the E5810 to the network and to GPIB and/ or RS-232 instruments as required.

To AC Power

To Enterprise

To RS-232

Network

Instrument

Typically Hub or

 

 

 

Switch

 

E5810A

 

OR

 

 

POWER

 

 

RS232

 

Tx

GP IB

 

 

!

LAN

Ln

 

 

 

LAN

 

 

 

 

 

 

GPIB

GPIB Instruments

GPIB

GPIB

GPIB

Chapter 2

55

Page 55
Image 55
Agilent Technologies E5810A manual Installing the E5810 on an Enterprise Network, Connecting the E5810 to the Network