Agilent Technologies E5810A manual Typical Power-On Sequence E5810 Description

Typical Power-On Sequence

E5810 Description

E5810 Hardware Description

This figure shows major steps in a typical power-on sequence for an E5810 that is connected to a network that supports Dynamic Host Configuration Protocol (DHCP) and Domain Name Service (DNS). If the network does not support DHCP and/or DNS, the power-on sequence may be different than that shown.

Power Applied

Display is blank, Power (Green) and Fault (Red) are ON.

Searching for DHCP Server PowerLANActivityGPIBRS232LAN/GPIBE5810AFaultGatewayPreset

Display displays message, Power (Green) is ON and Fault (Red) is OFF. This typically takes 20 to 30 seconds and can take up to 150 seconds if a DHCP Server is not present.

Display169displaysDHCPSearching.254Server.Hostname,58.10for...(if known) andPowerIP address,LANonlyActivityGPIBPowerRS(Green)232ELAN/GPIB5810Ais ON. FaultGatewayPreset

IP Address and Hostname Displayed

20 Chapter 1