Agilent Technologies E5810A manual On a Dhcp, Enterprise Network

Installing the E5810

Installation Flowchart

You can install the E5810 on an Enterprise (corporate) network that supports Dynamic Host Configuration Protocol (DHCP), an Enterprise network that does not support DHCP, or a Local network.

NOTE

If you plan to install the E5810 on an Enterprise network, contact your

Information Technology (IT) Department to see if the network supports

Dynamic Host Configuration Protocol (DHCP).

Installing the E5810 See these sections to install an E5810 on an Enterprise network that does

on a DHCP	support DHCP:
Enterprise Network	Before You Install the E5810
	Getting Network Information
	Installing the E5810 on an Enterprise Network
	Verifying Instrument Communication
	￿Installing and Configuring the Agilent IO Libraries Suite

Installing the E5810 on a non-DHCP Enterprise Network

Installing the E5810 on a Local Network

To install the E5810 on an Enterprise network that does not support DHCP, you may need to first configure the E5810 on a Local network and then install the E5810 on the Enterprise network. See these sections to install an

E5810 on an Enterprise network that does not support DHCP:

Before You Install the E5810

Getting Network Information

Configuring the E5810 on a Local Network

Installing the E5810 on an Enterprise Network

Verifying Instrument Communication

￿Installing and Configuring the Agilent IO Libraries Suite

If you plan to install the E5810 on a Local network, you may not need to contact your IT department. However, you will need to determine network parameters. See these sections to install and configure an E5810 on a Local network:

Before You Install the E5810

Getting Network Information

Configuring the E5810 on a Local Network

Verifying Instrument Communication

Installing and Configuring the Agilent IO Libraries Suite

38 Chapter 2