Power-On (Default) Settings
E5810 Description
E5810 Hardware Description
When power is first applied to the E5810 and the hardware
The E5810 uses these default configuration values until you set any other configuration values. The E5810 also uses these values when you press the Preset button and hold it down for >10 seconds. See Chapter 3 - Using E5810 Web Access for a description of each parameter.
Parameter | Default |
| Parameter | Default |
|
|
|
| |
DHCP: | ON | GPIB Address: | 21 | |
|
|
|
| |
IP Address: | 169.254.58.10 | GPIB Logical Unit: | 7 | |
|
|
|
| |
Subnet Mask: | 255.255.0.0 | COM1 | ||
|
|
|
| |
Default Gateway: | 0.0.0.0 | 9600 | ||
|
|
|
| |
DNS Server(s): | 0.0.0.0 | NONE | ||
|
|
|
|
|
Hostname: | none | Bits: | 8 | |
|
|
|
|
|
Description: | Agilent E5810 | Stop Bits: | 1 | |
| <MAC Addr> |
|
|
|
|
|
|
|
|
Universal Plug & Play: | ON | Flow Control: | NONE | |
|
|
|
|
|
LAN Keepalive (sec): | 7200 sec | SRQ: | RI | |
|
|
|
| |
I/O Timeout (sec): | 120 sec | Password | E5810 | |
|
|
|
|
|
GPIB SICL Interface Name: | gpib0 |
|
|
|
|
|
|
|
|
Preset Button The Preset button on the front panel of the E5810 is used to reset the E5810
Operationto its default configuration values (preset at the factory). As shown in the figure on the next page, the Preset button has two modes of operation:
If you depress the Preset button and release it in <10 seconds, only the E5810 password is temporarily changed and is reset to its default value (E5810). If you cycle power or reboot the E5810, the E5810 will return to the actual password that was previously set. All
existing configuration values remain unchanged.
If you depress and hold the Preset button for 10 seconds or more, all configuration values are reset to their factory default values and the E5810 is rebooted. All network connections to the E5810, if any, are also terminated without any cleanups.
Chapter 1 | 21 |
