Example:

Configuring the

E5810

Installing the E5810

Configuring the E5810 on a Local Network

This example shows one way to set various E5810 parameters on the Configuring your E5810 LAN/GPIB Gateway page, assuming the Enterprise network to which the E5810 will be connected does not support DHCP or DNS. Since the network does not support DNS, a Hostname cannot be used for this E5810. In addition, it is assumed the network does not allow UPnP, so Universal Plug and Play is set to OFF.

2.Click the Save button to save changes

3.Click Reboot E5810 to reboot and make changes effective

1.Set DHCP OFF Enter New IP Address

Enter New Subnet Mask Value

Enter New Default Gateway IP Address Leave DNS Server Address Blank Leave Hostname Blank

Set Universal Plug and Play to OFF.

Configuring the E5810 for Local Network Operation

If you plan to install your E5810 on a Local network, use the Configuring your E5810 LAN/GPIB Gateway page to set the parameters applicable to your Local network.

Where to go Next

To Install the E5810 on an Enterprise Network. Disconnect the E5810 from the Local network and go to “Installing the E5810 on an

￿Enterprise Network”.

To Use the E5810 on a Local Network. Leave the E5810 connected to the Local network and go to “Verifying Instrument Communication”.

54

Chapter 2

Page 54
Image 54
Agilent Technologies E5810A manual Example Configuring E5810, Enterprise Network