
| Using E5810 Web Access |
| Viewing and Modifying Configuration |
|
|
Parameter | Description |
[Default] |
|
|
|
Parity is used by the | |
[NONE] | Parity value is dependent on the peripheral device you connect to the |
| |
| this value. Available parity check options for the E5810 are NONE, ODD, |
| EVEN, SPACE and MARK. |
|
|
This parameter is the symbolic name of the | |
Interface Name | E5810. It is used in an Agilent SICL iopen operation to symbolically |
[COM1] | reference the |
| Remote |
| when specifying an |
| The |
| Interface Name. The maximum length of the |
| Name is 15 characters. |
|
|
Method used to request service from the | |
[RI] | the modem status line on the |
| Service ReQuests (SRQs). Available SRQ options for the E5810 are RI, |
| DCD, DSR, and CTS. |
|
|
A bit that indicates that a byte has just been transmitted. Every byte of | |
[1] | data is preceded by a start bit and followed by a stop bit. Available stop |
| bit options are 1 or 2. Stop Bits is the number of bits used to indicate the |
| end of a character frame in |
| The Stop Bits value is dependent on the peripheral device you connect to |
| the |
| set this value. Available stop bit options for the E5810 are 1 or 2. |
|
|
Subnet Mask | This value is used to enable the E5810 to determine if a client IP address |
[255.255.0.0] | is on the same local subnet as the E5810. When a client IP address is on |
| a different subnet, all packets must be sent to a subnet gateway. |
| See the Glossary for an example of a subnet. |
|
|
94 | Chapter 3 |