Installing the E5810

Installing the E5810 on an Enterprise Network

After connecting the E5810 to the Enterprise network, plug the E5810 AC power cord into an AC outlet and observe the power-on sequence. When the power-on sequence is complete, the assigned IP address of the E5810 is displayed on the second line of the front panel display. A typical display follows. See Chapter 1 - E5810 Description for power-on sequences.

NOTE

The Mains disconnect for the E5810 is to unplug the AC power cord from the AC outlet. The E5810 has no AC Power switch.

IP Address and Hostname Displayed

Display shows IP address (and Hostname, if known)

LAN/GPIB

Configuring the E5810 for Enterprise Network Operation

After the E5810 is installed on the Enterprise network, you c n check or set (as required) E5810 configuration parameters using the E5810 Web access that is accessed from your Web browser (Internet Explorer 4.0 or higher or Netscape Navigator 4.7 or higher). The steps to set E5810 configuration parameters are:

1Display the Welcome Page. To display the E5810 Welcome page, from your Web browser address line, type

http://<E5810 IP Address>, where <EE5810A IP Address> is the IP address displayed on the E5810 front panel displGateway.Then, press the Enter key.

56

Chapter 2

Page 56
Image 56
Agilent Technologies E5810A manual Lan/Gpib, Configuring the E5810 for Enterprise Network Operation