Agilent Technologies E5810A manual Rear Panel Features, Rack Mount Kit Optional

E5810 Description

E5810 Hardware Description

Rear Panel Features

This figure shows the rear panel features of the E5810.

LAN Port

Connect one end of a LAN patch cable to this port and connect the other end of the cable to a router/hub/switch.

OR

Connect one end of a crossover cable to this port and the other end of the cable to a LAN card on your PC.

GPIB Port

Connect one end of GPIB cable to this port and connect other end of cable to a GPIB instrument.

RS232 Port

Connect one end of RS-232 cable to this port and connect other end of cable to an RS-232 instrument.

LAN Activity Lights

When the green Ln light is ON, the E5810 is successfully connected to the LAN. When the green Tx light flashes, the E5810 is transmitting data onto the LAN.

Serial Number and Ethernet Address The E5810 Serial Number and Ethernet (MAC) Address are printed on a label on the underside of the E5810.

POWER Port

Connect AC power cord to this port and plug cord into an AC outlet. The E5810 does not have a power switch. The Mains disconnect is to unplug the AC power cord from the AC outlet.

The power supply automatically conforms to the input voltage and frequency supplied, within 100V - 240V (±10%) @ 47-63 Hz.

Rack Mount Kit (Optional)

As desired, you can mount up to two E5810 in a standard EIA rack using the E5810 Rack Mount Kit (E5810 Opt 100 or E5810-00100). The E5810 is one standard half-rack unit wide and one standard rack unit high. See the E5810-00100 Rack Mount Kit for installation instructions.

Chapter 1 23