Avaya 1600 manual Configure Pvcs ATM, Delete Dlci, Show Current DLCIs, Add New PVC

3. Configure FRF.12 Fragmentation

Displays the End-to-End Fragmentation Configuration submenu, which contains the following commands.

1. Enable/Disable End-to-End FRF.12

Enables and disables End-to-End

FRF.12.

2. Set Fragmentation Size

Sets the maximum fragmentation size, a value between 100-1,600 bytes.

Type the fragmentation size, and then press ENTER.

The PARTNER ACS 1600 DSL module displays a default or last-used value in parentheses to the left of the command prompt. To accept this value, press ENTER.

Select your choice.

3. Delete DLCI

Type the number of the port to delete, and then press ENTER.

4. Show Current DLCIs

Displays encapsulation information about the active DLCI values on per port basis.

You must restart the PARTNER ACS 1600 DSL module for any changes to take effect. For more information on restarting the PARTNER ACS 1600 DSL module, see the “PARTNER ACS 1600 DSL module basics” chapter.

3. Configure PVCS (ATM)

Displays the ATM PVC Config Menu, which contains the following commands to set the current Permanent Virtual Circuit (PVC) Virtual Port Identifier (VPI) and Virtual Circuit Identifier (VCI) values by port:

1. Add New PVC

Type the VPI, the VCI, and then choose a command from the ATM Encapsulation Configuration submenu.

1. AAL5 (None)

Displays the ATM Service Category Configuration submenu, which contains the following commands to set the service category:

1.CBR

2.UBR

Select your choice, and then follow the on-screen messages to set the Peak Cell Rate (PCR) value.

Avaya, Inc. - 51 - PARTNER ACS 1600 DSL module User Guide