Avaya 1600 manual Configure Login

C. Configure SNMP Community

Sets the SNMP community to which your device belongs (maximum = 39 alphanumeric characters). This name must match the name of the SNMP host. Type the name, and then press ENTER.

If SNMP you enable and the Community Name is null, SNMP goes into read-only mode.

T. Configure SNMP Trap Host IP Address

Sets the IP address of the system setup for trap operations. Type the IP address, and then press ENTER.

8.Configure Login

Displays the Password Configuration Menu, which contains the following commands to set the default User ID and the default User and Network Administrator passwords:

You must restart the PARTNER ACS 1600 DSL module for any changes to take effect. For more information on restarting the PARTNER ACS 1600 DSL module, see the “PARTNER ACS 1600 DSL module basics” chapter.

1. Change User ID

Changes the default User ID. Type the new User ID (maximum 17 alphanumeric characters), and then press

ENTER.

2. Change User Password

Changes the default User password. Type the new password (maximum 17 alphanumeric characters), and then press ENTER. Retype the new password, and then press ENTER.

3. Change NetMan Password

Changes the default Network Administrator password. Type the new password (maximum 17 alphanumeric characters), and then press ENTER. Retype the User password, and then press ENTER.

For more information on changing the User ID or password, see the "Administration" chapter.

Avaya, Inc. - 59 - PARTNER ACS 1600 DSL module User Guide